Package contents
- 1x DC 6.5-100V 100A 4 IN1 digital energy meter
- 1x 50A/75mv shunt
Specification parameters
- Working voltage: 6.5~100VDC
- Test voltage: 6.5~100VDC
- Rated power: 100A/10000W
- Measurement accuracy: 1.0 grade
Display format
Power: test range 0~10kW
- within 1KW, the display format is 0.0~999.9W
- 1KW and above, the display format is 1000~9999W
Energy: test range 0~9999kWh
- Within 10KWh, the display format is 0~9999Wh
- 10kWh and above, the display format is 10~9999kWh
Voltage: test range 6.5~100V
- Display format: 6.50~99.99V
Current: test range 0~100A
- Display format: 0.00~99.99
Key
- Electrical parameter measurement function (voltage, current, active power, energy)
- Voltage alarm function (over voltage alarm threshold, backlight and voltage flashing to alarm)
- The reset function of energy key
- Store data when power off
- Large-screen LCD (display voltage, current, active power, energy at the same time)
Backlight control
- Short press the key to turn on or off the backlight, the backlight has memory function, it can store the on or off state when power off
Reset energy
- Step 1: Long press the key until the power display area display “CLr”, then release the key
- Step 2: Short press the key, the energy value will be cleared and exit the reset flashing state
- Step 3: If there is no operation within 5 seconds, it means the energy value is not cleared and will exit the reset state
Set voltage alarm threshold
- Step1: Long press the key until the power display area display “SET”, then release the key
- Step2: After enter this state,
- the voltage area display the current high voltage alarm value
- the current area display the current low voltage alarm value
- and the last digit begin to flash, then you can short press plus 1
- when there is no operation over 3 seconds, it will switch the digit position automatically
- from the high voltage alarm value to the low voltage alarm value, there are total six digits
- the range of the voltage alarm threshold is 6.5
- Step3: After finish the setting, long press the key until the screen display “PASS”, your setting is done successfully and it will exit the setting state automatically
Precautions
- This module is suitable for indoor, please do not use outdoor
- Applied load should not exceed the rated voltage, current
- Wiring order can’t be wrong
Item specifics
- Dimensions: 8.96cm*4.96cm
- Accuracy Class: 1.0
- Operating Temperature: -10-60 degree
- Power Supply: DC
- Display Type: Digital Only
- DIY Supplies: Electrical
- Model Number: PZEM-051/100A
- Measuring Range: 0-50A
