AC Multifunction Voltmeter Meter  AC 80-260/100A Volt Amp power tester

$19.99  $16.99
Save: 15.01% off

  • Model: PZEM-061
  • Manufactured by: ROXDV

Always Free Shipping

 Sold Out 


AC Multi function meter energy power monitor AC 80-260/100A Volt Amp power energy tester with Current Transformer 110v 220v

AC Multifunction Voltmeter Meter  AC 80-260/100A Volt Amp power tester Voltmeter Ammeter Current Transformer 

Energy Power Monitor


A. Function

  • Voltage, current, power, energy
  • Overload alarm function (over power alarm threshold, the backlight and power flicker tips).
  • The power alarm threshold preset function (can set up their own power alarm threshold).
  • The power button clear function.
  • Power-down data storage function.
  • Large-screen LCD screen full display function (display voltage, current, active power, power).
  • Backlight.


Display Interface

  • Displayed by the large-screen LCD screen at the same time voltage, current, power, power parameters, as shown in FIG

Display Format

  • Power: measurement range 0 ~ 22kW
  • 1kW display format within 0.0 ~ 999.9W
  • From 1kW display format 1000 ~ 9999W
  • 10kW above the display format 10.0 ~ 22.0kW
  • Power: measurement range 0 ~ 9999kWh
  • 10kWh within the display format 0 ~ 9999Wh
  • Above 10kWh display format 10 ~ 9999kWh


  • Test Range 80 ~ 260V
  • Display Format 80 ~ 220V

4. Current

  • Test Range 0 ~ 100A
  • Display Format 0.00 ~ 99.99A.


The backlight control

  • By short press the button to turn on or off the backlight, the backlight status store automatically 

Clear The power 

  • Press the power button 5 seconds until the digital display window flashes, then release the button
  • If you press the button again, the consumption data will be cleared and stop flashing
  • If you hold the button for 5 seconds until no flashing, the charge data will be cleared. 

3. The power to set the alarm value

  • Press the button, when the LCD screen display "SET CLr" after the release button, set the value into the power status report
  • Power area displays the current value of the power alarm, when lowest digit starts to be blinking, then you can press the button of the digital +1, when there is no key operation more than three seconds, short digital set as above automatically
  • After setting, press the button more than five seconds to save automatically and exit, the scope of active power threshold set for the 0.0 ~ 22.0kW


  • This module is suitable for indoor, not for outdoor use
  • Applied load can not exceed the rated power
  • The wiring order must be correct to avoid any circuit burns


  • Working voltage: 80 ~ 260VAC
  • Test voltage: 80 ~ 260VAC
  • Rated power: 100A / 22000W
  • Working Frequency: 45-65Hz
  • Measurement accuracy: 1.0

upc 780456278726

Connect with

Your IP Address is:

This site chose Symantec SSL for secure e-commerce and confidential communications

Copyright © 2002-2019 Roxsat Eyeondvr New Jersey USA. All Rights Reserved.
ROXSAT is not responsible for any errors, omissions or inaccuracies in the material provided on this site. All prices are subject to change without notice.