| Sub-Menu:
SEARCH CHANNEL (
new user start from here ...)
- Antenna
Setting
- Manual Search
- Auto Search
Antenna Setting
you need to have the bar
shown , it
locked the signal and ensure your picture quality, must be over 30 and
turn into yellow color.
No quality bar =
No picture
Use this screen when you are tunning the
dish to get the signal, after that, scan the satellite to get the chanells
list.
(Actually, most of the channels are preprogrammed,
you scan for the latest updated channels)
Satellite Name: T5Ku
SatellitesTelstar 5 ( or choose what you like)
Normal LNB DVB321: C 5150MHz / Ku10750Mhz
Universal LNB DVB321-2: C 9750 MHz / Ku 10600
MHz
LNB Type: Ku to 10750 ( if you have Universal
LNB, then set to 10600) (Note: This is not the Transponder or channel's
frequency)
DiSEqC Port: OFF (ON for DiSEqC 1.2 switch
)
Motor Setting: Disable (if you don't have
H-H mount motor)
22KHz: OFF ( select ON only when you are
using 22K tone switch)
0/12 Volts Switch: OFF
LNB Power: ON
FTA Only: NO ( not really matter, it is just
for searching channels, search all or search FTA only)
Menu Search This is the
screen you need, when the bar turns to yellow, satellite is locked
recommend you to chosethese settings for
aimming, because some of Transponder frequency have been changed. To ensure
the T5 signal you can get.
Telsatr 5:
| frequency |
11836 |
| Symbol Rate |
20765 |
| Pol |
VER |
Start to aim your dish to satellite T5 or
your selection, till you get the signal ,
must be over 30 %.
Search Start: If you get the signal, then
you can do this function to auto search and update the channels list.
Setup With H-H-Mount
Motor SG-2100
1.
Enable the Motor setting , press ok to go inside page
2.
Choose the working Freq/Symbol/Polar
3.
Drive the Mootr
- Drive
continuously to move motor faster
- nudge
motor to fine tune
4.
when get the quality bar , then press Store Present Satellite Postion.
5.
exit to scan the satellite channels.
|
