|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|||
|
|
|
||||||
|
|
|||||||
|
|
|||||||
|
|
|
|
|||||
|
|
|||||||
|
|
|
||||||
|
|
|||||||
|
|
|
|
ZINWELL ZDX-7000FTA Receiver's System Menu From left you find the System Menu screen captured here has most of the installation related settings that you need to verify or change. LNB PORT SETUP Telstar5 is the default This is the page that you need BEFORE setup the outside dish and aiming, 1. LNBF Setup standard C/Ku LNBF LO Freq is this LNB: Normal 5150MHz 10750Mhz ( If you have Universal LNBF such like 321-2 LNBF , then use Universal LO - Low 9750 ,High 10600 )
Installation Use the Search Channel page when tuning your outdoor dish. You need to have the Red_Yellow_Green Signal Quality bar shown, it locked the signal to ensure your picture quality, must be over 90. No quality bar = No picture To Add/Change the Transponder frequency -- Hi-light the Frequency and press OK, then you can make any change. Start up screen to set up your satellite dish 1. Press Menu 2. Select Installation, press OK 3. Select Search Channels 5. Use The 2nd transponder frequency by Hi-light the TP and press OK, select: Tp2, press OK again Freq:11836 SR:20760 Pol: Ver Pow:ON LNB:10750 22K:OFF
6. Tune outdoor dish, until you get signal quality Color bar, no quality bar = no picture 7. To choose Scan, press Remote Green Button, it will show the screen of scanning the channels on the satellite. 8. After the Scanning finish, it will auto save and exit to channel view, job done.
To add a new transponder 1. Goto Installation, Search Channel, 2. Hi light the TP , pressOK button, 3. Press Remote Red button to ADD TP, or Press Yellow button to Delete 4. Press Down or Right Arrow to Hi light the Frequency, press OK, input number by press remote control digits, press OK when finish., example 12152 5. Press Down Arrow to hi light the Symbol Rate,press OK, input number by press remote control digits,Press OK when finish. example 20000 7. Press Down Arrow to hi light the Polarity, pressOK to chang color of red , press Left or Right Arrow to select Vertical or Horizontal, press OK
NTSC vs PAL to switch between NTSC and PAL , to solve the problem by
Please hold "RECALL" key on the Remote Control for 5 sec. |
